User's Manual

76
ENGLISH
III WI-FI SETUP FOR THE AEROSPHÈRE SMALL & LARGE
Time required: 5 minutes
Once completed: the AeroSphère speaker is connected to your Wi-Fi network. Now you are ready to use AirPlay, DLNA and all audio sources
from the AeroSphère Base ( FM, DAB+, audio CD ).
OVERVIEW

wireless network ). There are three different methods you can use for the Wi-Fi setup.
WI-FI SETUP METHOD WHEN TO USE THIS METHOD
WAC * You can use your iPhone, iPad, iPod Touch. They require iOS 7 or higher.
WPS Your Wi-Fi router has a WPS push button for easy network setup.
AeroSphère Network Setup webpage Advanced method go to the “Feature Guide” on aerosphere.genevalab.com
 time.
WI-FI SETUP WITH WAC ( WIRELESS ACCESSORY CONFIGURATION )
What is needed for this setup?
1. An iOS device ( Phone, iPad or iPod Touch ) with iOS version 7
or
higher.
2. The iOS device must already be connected to your Wi-Fi network
Instructions
1. 
two times repeatedly in green. When you are using the AeroSphère

and go to step 3.
2. 
enable the Wi-Fi Setup with WAC manually:
Hold the “SETUP” button on the back for 10 seconds, until the
 green.
3. Go to Settings of your iOS device and select Wi-Fi.
4. Wait until you see the entry “SET UP NEW AIRPLAY SPEAKER” on
the lower part of the display. Select it.
5. Press “Next” on the upper right.
6. The iOS device will now automatically transfer its Wi-Fi settings to
the AeroSphère speaker.
7. Wait until the display of the AeroSphère speaker has successfully

green to a constant green.
What is WAC?
WAC is an easy Wi-Fi setup method for iOS devices ( iPhone, iPad, iPod
Touch ). By default this Wi-Fi setup method is enabled when you use

 green.
Troubleshooting
 Repeat the
procedure.
 Make sure your iPhone, iPad or iPod touch are using iOS version 7
or higher
 Make sure your iPhone, iPad or iPod touch is connected to a Wi-Fi
network
 Try another Wi-Fi setup
method.
 Check the networking troubleshooting guide on the Genevalab.com
Support
page.
3
4
5
6
WI-FI SETUP WITH WPS
What is needed for this setup?
Your Wi-Fi router needs to support WPS. No computer or smartphone is needed for this setup.
3
4
Instructions
1. Turn the AeroSphère speaker on.
2.  green.
3. Press the “SETUP” button on the back of the AeroSphère speaker.
4. On the Wi-Fi router press the WPS button. Typically a light on the

button for a few seconds. The AeroSphère speaker and the Wi-Fi
router are now starting to connect to each other.
5. Wait until the display of the AeroSphère speaker changes to button
green. This can take up to a minute. Now you are connected to your
Wi-Fi network.
What is WPS?
WPS ( Wi-Fi protected setup ) is a simple way to connect a new device
to a Wi-Fi network. WPS is a common feature on today’s Wi-Fi wireless
routers or Wi-Fi access points. When pushing the “SETUP” button on
the AeroSphère Small or Large and the “WPS” button on the Wi-Fi
access point within about a minute, the AeroSphère Small or Large will
automatically connect to the Wi-Fi network.
Troubleshooting
 Repeat the procedure.
 Upgrade the software on your Wi-Fi router.
 Try another Wi-Fi setup method.
 Check the networking troubleshooting guide on the Genevalab.com
Support page.
WI-FI SETUP WITH THE AEROSPHÈRE NETWORK SETUP WEBPAGE
Follow the detailed description in the “Feature Guide” on aerosphere.genevalab.com