Parts List

Setting the magazine .GR16/G4 GR16/G4. Firing
27 28
Setting the magazine Firing
Make sure to install the magzine upwards
and into the body.
It is installed properly when you heard a
click sound.
Firing
Click
Remove the protective cap only when
you are ready for firing the gun.
Set the Selector Lever to Semi or
Full Auto.
Warning
► Make sure to set the magazine upwards.It is securely installed when you heard a click sound.
► Confirm that the safety lever is set to Safety position and do not place your finger on the trigger.
Warning
► Select a safe place for operating the air gun.
► Never put your finger on the bolt when operating the air gun.
Insert the magazine into the body until you hear
a click sound.
Press the magazine release. Pull the magazine out of receiver.
Setting the magazine To release the magazine
Open the cover of magazine.
Load G&G 5.95mm BB pellets into the
magazine.The magazine is capable of
holding approximately 450 pellets.
After the BB pellets had been loaded.Close
cover and turn the gear on the bottom until
the sound changes.
Setting the magazine
Click
Cautions on motor and battery
After operation
1. Charge the battery if the firing cycle becomes slow.
2. Pausing using the air gun for about 5 to 10 minutes
after firing about 500 rounds, in order to ensure
long service lives of the motor and battery.
1. Remove magazine ,fire at a safe direction for 2-3
seconds,then push the forward assist knob to
release the spring,and have the selector set into
safety mode.Make sure that
the barrel is empty.
2. Always disconnect the
battery and attach the
protective cap whenever
you do not operate the
air gun.
Press