User Manual

WWW.GUAY2.COM Manufactured by G&G Armament Printed in Taiwan
Manual
Instruction
GR16 C.Q.W.
Close Quarter Weapon
Plastic
SETTING MAGAZINE
Automatic firingSingle shot
1.Push the butt plate lock ( both sides )
2.Pull out the butt plate.
1.Charge up the battery.
2.Charging will be completed after 3 hours.
Take off the cover. Pull out the wire connector. Connect battery plug with the connector
until you heard a click sound.
Insert the battery into stock. Reinstall the battery cover and butt plate.
Do not catch your fingers in the dummy bolt.
Never hold the gun sideways as the BB
pellets will curve right or left.
It is strongly recommended the use of
G&G BB pellets only. Using low quality
BB pellets will shorten product life span
and void product warranty.
Safety On Semi Auto Full Auto
The trigger cannot be pulled
Rail system
Detachable rear sight
Extend battery stock
Stock release lever
Trigger
Selector lever
Flash suppressor
Outer barrel
Hi-cap 450R magazine
G-11-019
NI-MH 9.6V 1400 mAh
Charging handle
Open the cover of magazine.
Load G&G 5.95mm BB pellets into the
magazine.
Close the cover plate then turn the gear
until the sound changes.
Insert the magazine until you heard a click
sound.
COMPONENTS
FIRING MODE & SAFETY
BATTERY SETTING
HOP-UP ADJUSTMENT
Best Position.
Too much Hop-up.
( Turn the adjust lever toward Normal )
Not enough Hop-up. ( Turn the adjust lever toward Hop )
or Too much Hop-up. ( Turn the adjust lever toward Normal )
Click
Click
Turn to Normal Turn to Hop
Folding front sight
RECOMMENDED
BATTERY TYPE
1.
2.
3.
4.
Please select quality battery with the CE approval, to
avoid any unnecessary damage on the product.
Please use either 8.4V or 9.6V battery, if different
voltage used, it might damage the product.
Remove the battery from the product when it is not in
use.
Do not wet nor incinerate the battery, nor to deform
the terminal.
New Blow Back Pneumatic System
True to the faith of mimicking real life firearms, G&G is proud to present
its new Pneumatic Blow Back system to its line of airsoft
guns.Conventional airsoft blow back utilizes tow hook springs to mimic
real life bolt actions, which often lead to excess wear and tear and poor
reliability in the gear box. To alleviate the problem of conventional
systems, G&G has independently developed the Pneumatic Blow Back
system; a piston driven, gas operated mechanism to better mimic real
life bolt actions.
This new technology utilizes compressed air to move the bolt, which
enables the action without adding extra stress to the gear box.
This class leading system represents a significant milestone in the airsoft
industry.
Reinforced grip