User Manual

Never use CRC-556,
WD40 or other
corrosive lubricant.
Make sure no dirt gets into the
chamber to avoid clogging of
bullets.The hopping up operation
may be unstable for 200 to 300
rounds after using silicone oil,
this is the normal operation fo
the gun.
When Bullets Are Clogged
After Operation
Cautions on Motor and Battery
SEMI ( Single Shot ) AUTO ( Automatic Firing )
Make sure insert the magazine
upwards and into the body. When it is
properly inserted you will hear a click
sound.
Set the selector lever to “SEMI - ”
or “AUTO - A” position.
Push the safety to unlock trigger
then pull the tigger to fire.
Remove the magazine, direct
the muzzle into a safe direction
then fire the gun in semi-auto
mode for a few shots. Set the
safety to the safe position.
Always disconnect the battery
and attach the protective cap
whenever you do not operate
the air gun.
Charge the battery if the firing
cycle becomes slow.
Give the air gun a rest for 5 to
10 minutes after firing about
500 rounds, in order to ensure
long service lives of the motor
and battery.
If bullets are clogged, remove
then and apply a few drops of
G&G silicone oil into the
chamber from the magazine
entrance. Apply G&G silicone oil
for 0.5 to 1 sec, to obtain
smooth continuous firing.
Step 1
Step 2
Step 3
Step 4
Remove the protective cap only when
you are ready for firing the gun.
CAUTION
WARNING
There are possible cases that no firing
occurs after pulling the trigger in the semi
auto mode. In such cases, do not pull the
trigger furiously. Fire 5 to 6 shots in the
full auto mode and then return to the semi
auto operation.
A
13 14