Parts List

Warning
Warning
13
Maintenance
14
Trouble shooting
Maintenance for low FPS
Removing loose pellets
► Do not jam the cleaning rod into the barrel by force.
► Should the BB’s remains inside the barrel after following the instruction above,with
the protection cap off the barrel, point the gun to a safe direction, and discharge
any loosened BB’s in semi-automatic mode.
1. Return the hop-up dial to the Normal position and
insert the cleaning rod from the lead edge of the barrel.
2. To remove clogged BB’s, carefully insert the cleaning rod inside
the flat tip facing down as shown to the left.
► Make sure no dirt gets into the chamber to avoid clogging of pellets.
► Hop-up may be unstable for the first 200 to 300 rounds after using silicone oil,
this is the normal operation of the gun.
► Never use CRC-556, WD40 or other corrosive lubricant.
1. Spray a few drops of silicone oil or teflon oil into the pellet
entrance. After insert BB pellets into the magazine, fire the
gun for up to 200~300 pellets.
2. To complete the cleaning, use the cleaning rod (with cotton)
to remove excess oil.
1 Check to ensure that your lubricant reservoir is at the required level for optimal operation. This can cause mechanical malfunctions
if not properly maintained.
2 Point the muzzle in a safe direction and inspect the chamber or feed tube if the weapon doesn't fire. Typically, a pellet or BB may jam
inside the chamber, causing the airsoft gun not to fire, or other debris may be inside the barrel or chamber. Place the airsoft gun on
"Safe." Look inside the chamber or feed tube to locate and remove the jam or debris. A slender pointed tool or tweezers can be used
to grab jammed ammunition or other debris.
3 Check all O-rings, air seals and pistons if the weapon isn't shooting at its indicated velocity range. Low air pressure causes poor
range performance. Consult your specific manual to access the O-rings, seals and pistons. Look for any visible damage or worn spots.
Replace the items if needed.
4 Check the CO2 cartridge, if the gun is so equipped. Often, poor performance is caused by low CO2 levels. You may hear a loud
burping sound, or the airsoft gun won't fire properly when the CO2 is low or empty. Ensure that the CO2 cartridge is properly installed
and sealed correctly. Installing a fresh cartridge generally corrects this problem.
5 Adjust your sights or scope if the airsoft gun isn't firing on target accurately. If no other problems are evident, fine tuning the sights
or scope will bring your shots back on target. Often, the sights can become out of tune through transport, improper storage or dropping
the weapon. Consult your specific manual for detailed sight adjustment procedures.
SYMPTOM
When Hopping Up is improper
PeIlets flying upwards
Cannot adjust
Frequent pellet clogging
Too much hop setting.
Too much hop setting.
Hop packing contaminated by oil or dirt.
Dirt inside a barrel.
Worn or damaged hop packing.
Damaged adjustment lever or other pasts.
Too much hop setting.
Improper size BB pellets.
Dirty hop packing.
Gradually return adjustment lever towards backward.
Gradually return adjustment lever towards forward.
Fire pellets equivalent to 4 to 5 magazine or clean the chamber using
cleaning rod.
Purchase the replacement part at your dealer or from G&G and replace it.
Purchase the replacement part at your dealer or from G&G and replace it.
Gradually return adjustment lever towards Normal.
Use the BB pellet supplied by G&G Armament.
Clean using the cleaning rod or consult your dealer or G&G for repair.
POTENTIAL CORRECTIVE
Short flying distance
of pellets
(less hopping up effect)