Installation Guide

 Carefully roll the floor back onto the adhesive covered part of the trailer floor – do not flop
material back in place! – The spunbound backing helps the adhesive bond the flooring more
securely to the substrate, but when set back into place haphazardly, it could lead to air trapped
under the flooring, resulting in more work during the remaining steps of the installation
process.
 Using a hundred pound roller, work any air pockets out and ensure the adhesive is evenly
distributed – Work from the center of the floor out to the edge near the wall. This helps push
out any trapped air and evenly spread out the adhesive under the flooring.
 Repeat the above steps for the remaining half of the floor.
 Roll the entire floor once both sides are done to finish – Again, work from the center to the
edges.
 Give the adhesive plenty of time to cure– Allow the adhesive to fully cure over the course of
24 hours (depending on the local humidity).
 Install trim pieces along the flooring edges to give your new floor a finished look.