Installation Instructions

NOTE: For custom t, always allow product to relax in place before

trimming around edges and corners.

Step 4 - Trim.

Trim oor to t around poles, boards, etc. using a utility/rug knife or

scissors. Trim edges along exterior walls leaving ¼” gap to allow for

expansion/contraction.

Butt-type seaming guidelines.

Fold back edge of roll #1 and wipe clean. Attach tape along roll #1’s edge

(leaving 2” of tape exposed) and fold back into position.

Fold back roll #2 and wipe bottom edge clean. Carefully align along edge

of roll #1. Do not stretch mat or tape when applying.

Let G-Floor “ﬂoat” between exterior walls to allow for expansion

and contraction.

OPTIONAL - Taping.

After product has been allowed to relax in place, if you choose to hold

down edges or seams between two oor protectors, we recommend using

indoor/outdoor carpet tape or a vinyl spray adhesive.

COMPLETED INSTALLATION

Trim carefully around edges, leaving ¼” gap

Consumer Installation Sheet