Owner manual

79
X4-Drive
Each band can be set to one of 4 Modes – ‘Diode’, ‘OTA’, ‘OpAmp’ and
‘HalfRect’ – with each offering a different distortion flavour. There is a band-
pass filter before the drive stage, which can be adjusted using the Pitch and
Width controls. The Drive control sets the amount of distortion, while the Lp
control adjusts a 1-pole low-pass filter after the drive stage.
X4-Comb
The Pitch and Feed controls set the frequency and feedback amount of the
comb filter.
The Mode control sets the comb polarity to positive or negative. Each band
features an optional pre-delay which is turned on/off using the PrePwr
control and set using the Pre parameter (whether this parameter is set in
seconds or tempo-based values depends on the state of the Sync control).
The Hp and Lp controls adjust 1-pole high-pass and low-pass filters in the
comb signal path.
X4-Delay
The Time and Feed controls adjust the delay time and feedback respectively.
The Time control is set in seconds or tempo-based values depending on the
state of the Sync control.
Each delay band also features a pre-delay, which is adjusted using the
TimePre control. Whether this is set in seconds or tempo-based values
depends on the state of the SyncPre control.
The Hp and Lp controls adjust 1-pole low-pass and high-pass filters within
the feedback path.