Owner's Manual

12 13
• When completely seated, you should be able to see a small portion of
thebarrel assembly inside the magazine slot (3).
• Once in position, tighten the locking screws.
• Misalignment will cause poor performance and potential harm to the airgun.
NOTICE – Failure to tighten these locking screws can cause serious
damage to the rifle if fired.
Pelletprobe:
• Start by pushing the sidelever to its rear position.
• Set the safety to its safe position.
• Then remove the pelletprobe locking screw (1).
• Pull the probe rearwards, replace and tighten the screw again.
• Uncock the rifle, see cocking and loading section.
NOTICE – Never fire the gun without pelletprobe mounted.
2
Notes for you own settings
Tip: Make note of the factory setting before you start tuning the rifle.
Caliber
Regulator Pressure
Main Power Setting
Power tuning adjuster
Energy
Velocity
Pellet Weight
Pellet Type
Distance
Remarks
Changing Caliber
When changing calibre on the system for the first time, be sure to follow
these directions closely to avoid unwanted damage.
Make sure pelletprobe has the same caliber as the barrel before mounting.
Make sure rifle is uncocked!
Barrel:
• Loosen screws on top of the breechblock (2).
• Pull the barrel out of the system.
• Insert new barrel and make sure the small slot in the barrel breech lines
up with the guide pin inside the breech block.
1 3