Owner's Manual

10 11
Adjusting the power
Setting the power on the Dreamline can be done with three external adjustments.
1. Front power adjuster (1) - The airflow adjuster is located on the left front
side of the breechblock. This gives you the ability to adjust the power from
high to low. Low setting is for low power on all caliber. Caliber Setting is max
power for selected caliber. Variations in appearance might occur.
NOTICE – NEVER fire the airgun without air. Doing so may damage the
valve assembly and will void your warranty!
2. Rear power adjuster (2)– The spring tension adjuster is located on the
left rear side of the breech block.
The spring tension adjuster wheel is a quick way to fine tune the power and
accuracy of your rifle and has 7 fixed levels.
Simply rotating the wheel while the gun is uncocked in either direction will set
the power from Maximum to Minimum.
It will read letters on one side and figures on the other side as there can be
small difference in power between the two sides. 1 and E is on the low side
and 5 and A is on the high side.
NOTICE – NEVER adjust the power when rifle is cocked. Doing so might
damage the power-adjuster wheel and will void your warranty!
3. Externally Adjustable Regulator
The adjustable AMP regulator is installed in the dreamline. It is located
either on the bottle adapter (1) or installed within the Tube with an accessible
hole pointing downwards (2).
To adjust the regulator pressure higher, turn the regulator AMP screw counter-
clockwise slowly while looking at the regulator manometer located on the right
hand side of the gun. To lower the regulator pressure, turn the regulator AMP
screw clockwise a quarter turn at a time, dry firing the rifle until the correct
pressure is achieved. Make sure your rifle is not loaded before dry firing.
NOTICE – Fire in a safe direction.
NOTICE – NEVER adjust the regulator above 160 BAR as damage to the
system may occur and will void your warranty!
NOTICE – NEVER use the gun below the set regulator pressure as damage
to the system may occur and will void your warranty!
2
2
1
1
1
2