Owner's Manual

6 7
A quick connector is supplied with the rifle and is threaded with a 1/8” thread.
Make sure that the thread is the same at the charging source before you attach it.
Charging the rifle
Fillprobe Type MkI:
Insert the fill probe into the rifle filler
hole located at the end of the air tube.
Close ventilation screw on the charging source. Charge the rifle to wanted pressure.
Always check the pressure on the charging source, they have in most cases a
more reliable gauge. The gauge on the rifle is more of an indicator to see if you
need to charge or not.
If a hand pump is used the moisture trap must be drained at regular Intervals
during the pumping cycle.
WARNING: Only dry air should be used! Under no circumstances should oxygen
or any other gas be used to fill the airtubes! This could result in a serious serious
injury or death.!
Quick Connector MkII:
Push the connector over the
male connector.
How to load the magazine
To load the Side-Shot magazine, start by rotating the center lid-lock (1) until you
are able to remove the lid (2). Twist the inner pellet tray (3) counterclockwise
until you hit the stop. Put a pellet into the first position (4) head first while holding
your finger under the hole to stop it, release the pellet tray as the pellet you
inserted will hold the magazine in place. Continue placing the rest of the pellets
HEAD FIRST, make certain all the pellets fall in correctly into its slot (5). Once the
magazine has been filled, put the lid back into position and twist the lid-lock until
it is the opposite position of the cutout. Our guns are tested and tuned in the
factory for best performance and accuracy with JSB pellets.
2
4
3
1
5