SDS
21/09/2016 EN (English US) 7/11
FVP ST
A
Y TUNED MULTI-SYSTEM
A
DDITIVE 16 FL.OZ.
Safety Data Sheet
according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations
Eth
y
lbenzene (100-41-4)
Surface tension 0.029 N/m
Log Koc
log Koc,PCKOCWIN v1.66; 2.71; Calculated value; Koc; PCKOCWIN v1.66; 517.8; Calculated
value
2-Propanol (67-63-0)
Surface tension 0.021 N/m (25 °C)
12.5. Other adverse effects
No additional information available
SECTION 13: Disposal considerations
13.1. Waste treatment methods
Waste disposal recommendations :
Dispose of contents/container to appropriate waste disposal facility, in accordance with local,
regional, national, international regulations. . Avoid release to the environment.
Additional information : Handle empty containers with care because residual vapors are flammable.
Ecology - waste materials : Hazardous waste due to toxicity.
SECTION 14: Transport information
In accordance with ADR / RID / IMDG / IATA / ADN
US DOT (ground): UN1993, Flammable liquid, n.o.s. (Petroleum Distillates and Isopropanol), 3, II, Limited Quantity
ICAO/IATA (air): UN1993, Flammable liquid, n.o.s. (Petroleum Distillates and Isopropanol), 3 , II, Limited Quantity
IMO/IMDG (water): UN1993, Flammable liquid, n.o.s. (Petroleum Distillates and Isopropanol), 3 , II, Limited Quantity
Special Provisions: IB2 - Authorized IBCs: Metal (31A, 31B and 31N); Rigid plastics (31H1 and 31H2); Composite (31HZ1). Additional
Requirement: Only liquids with a vapor pressure less than or equal to 110 kPa at 50 C (1.1 bar at 122 F), or 130 kPa at 55
C (1.3 bar at 131 F) are authorized
T7 - 4 178.274(d)(2) Normal............. 178.275(d)(3)
TP1 - The maximum degree of filling must not exceed the degree of filling determined by the following: Degree of filling =
97 / 1 + a (tr - tf) Where: tr is the maximum mean bulk temperature during transport, and tf is the temperature in degrees
celsius of the liquid during filling
TP8 - A portable tank having a minimum test pressure of 1.5 bar (150 kPa) may be used when the flash point of the
hazardous material transported is greater than 0 C (32 F)
TP28 - A portable tank having a minimum test pressure of 2.65 bar (265 kPa) may be used provided the calculated test
pressure is 2.65 bar or less based on the MAWP of the hazardous material, as defined in 178.275 of this subchapter,
where the test pressure is 1.5 times the MAWP
14.2. UN proper shipping name
Proper Shipping Name (DOT) : Flammable liquid, n.o.s. (Petroleum Distillates and Isopropanol)
Class (DOT) : 3 - Class 3 - Flammable and combustible liquid 49 CFR 173.120
Hazard labels (DOT) : 3 - Flammable liquid
DOT Symbols
:
G - Identifies PSN requiring a technical name
Packing group (DOT) : II - Medium Danger
DOT Special Provisions (49 CFR 172.102) : IB2 - Authorized IBCs: Metal (31A, 31B and 31N); Rigid plastics (31H1 and 31H2); Composite
(31HZ1). Additional Requirement: Only liquids with a vapor pressure less than or equal to 110
kPa at 50 C (1.1 bar at 122 F), or 130 kPa at 55 C (1.3 bar at 131 F) are authorized
T7 - 4 178.274(d)(2) Normal............. 178.275(d)(3)
TP1 - The maximum degree of filling must not exceed the degree of filling determined by the
following: Degree of filling = 97 / 1 + a (tr - tf) Where: tr is the maximum mean bulk temperature
during transport, and tf is the temperature in degrees celsius of the liquid during filling
TP8 - A portable tank having a minimum test pressure of 1.5 bar (150 kPa) may be used when
the flash point of the hazardous material transported is greater than 0 C (32 F)
TP28 - A portable tank having a minimum test pressure of 2.65 bar (265 kPa) may be used
provided the calculated test pressure is 2.65 bar or less based on the MAWP of the hazardous
material, as defined in 178.275 of this subchapter, where the test pressure is 1.5 times the
MAWP
DOT Packaging Exceptions (49 CFR 173.xxx) : 150
DOT Packaging Non Bulk (49 CFR 173.xxx) : 202
DOT Packaging Bulk (49 CFR 173.xxx) : 242
14.3. Additional information
Emergency Response Guide (ERG) Number : 128