SDS

FVP CARBURETOR & FUEL INJECTOR CLEANER 12 FL.OZ.
Safety Data Sheet
according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations
21/12/2016 EN (English US) 3/9
6.4. Reference to other sections
See Heading 8. Exposure controls and personal protection.
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Additional hazards when processed : Handle empty containers with care because residual vapors are flammable. Keep away from
heat,sparks,open flames,hot surfaces. - No smoking.
Precautions for safe handling : Wash hands and other exposed areas with mild soap and water before eating, drinking or
smoking and when leaving work. Provide good ventilation in process area to prevent formation
of vapor. No open flames. No smoking. Obtain special instructions . Do not handle until all
safety precautions have been read and understood. Eliminate all ignition sources if safe to do
so.
Hygiene measures : Wash hands and other exposed areas with mild soap and water before eating, drinking or
smoking and when leaving work. Do not eat, drink or smoke when using this product. Wash
affected areas thoroughly after handling. Wash contaminated clothing before reuse.
Contaminated work clothing should not be allowed out of the workplace. Separate working
clothes from town clothes. Launder separately. Remove contaminated clothes.
7.2. Conditions for safe storage, including any incompatibilities
Technical measures : Comply with applicable regulations. Proper grounding procedures to avoid static electricity
should be followed. Use only non-sparking tools. The floor of the depot should be impermeable
and designed to form a water-tight basin. Provide local exhaust or general room ventilation.
Ground/bond container and receiving equipment.
Storage conditions : Keep only in the original container in a cool, well ventilated place away from : Keep container
closed when not in use. Keep in fireproof place.
Incompatible products : Strong bases. Strong acids.
Incompatible materials : Sources of ignition. Direct sunlight. Heat sources.
7.3. Specific end use(s)
Follow Label Directions.
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Ethylbenzene (100-41-4)
USA ACGIH ACGIH TWA (ppm) 100 ppm
USA ACGIH ACGIH STEL (ppm) 125 ppm
USA OSHA OSHA PEL (TWA) (mg/m³) 435 mg/m³
USA OSHA OSHA PEL (TWA) (ppm) 100
USA OSHA OSHA PEL (STEL) (mg/m³) 545 mg/m³
USA OSHA OSHA PEL (STEL) (ppm) 125 ppm
Distillates (Petroleum), Hydrotreated Light (64742-47-8)
USA ACGIH ACGIH TWA (ppm) 200 ppm 8 Hours
8.2. Exposure controls
Appropriate engineering controls : Local exhaust venilation, vent hoods . Ensure good ventilation of the work station.
Personal protective equipment : Gloves. Safety glasses. Avoid all unnecessary exposure.
Hand protection : Wear protective gloves.
Eye protection : Chemical goggles or safety glasses.
Skin and body protection : Wear suitable protective clothing.
Respiratory protection : Wear respiratory protection.
Other information : Do not eat, drink or smoke during use.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Physical state : Liquid
Appearance : Liquid.
Color : Colourless to light yellow.
Odor : Characteristic.