Installation Instructions
Table Of Contents
- Foreword
- Product Safety and RF Exposure Compliance
- Before using this product, read the operating instructions for safe usage contained in the Product Safety and RF Exposure booklet enclosed with your radio.
- ATTENTION!
- This radio is restricted to occupational use only to satisfy FCC RF energy exposure requirements. Before using this product, read the RF energy awareness information and operating instructions in the Product Safety and RF Exposure booklet enclosed wi...
- For a list of Motorola-approved antennas, batteries, and other accessories, visit the following website: http://www.motorolasolutions.com/governmentandenterprise
- Document Copyrights
- Disclaimer
- Trademarks
- VHF Vehicle Roof-Top Antennas HAD4021A HAD4022A
- Installation Manual
- Introduction
- Tuning Instructions for the HAD4022A Gain Antenna
- FCC Requirements
- Motorola Recommendations for Vehicle Roof-Top Antenna Locations
- Required Tools and Materials
- Installation Procedure
- Connector Fabrication (Mini-UHF)
- Tuning Chart for HAD4022A
- Product Safety and RF Exposure Compliance
Connector Fabrication (Mini-UHF) 11
6. Push the shell forward until it rests on
the connector body, and then push
the crimp forward allowing the braided
shielding to be compressed between
the crimp and the body of the
connector.
7. Use crimp area E of the crimping tool
shown in Figure 9 on page 9 to form
the crimp into place.