User's Manual

8A535X01 Rev. Preliminary-02 Page 6 of 19
This product does not contain customer serviceable components therefore never disassemble the
product.
IMPORTANT
If an outdoor antenna is connected, make sure the system is always grounded to allow
for protection against voltage surge and built-up static charges. Outdoor antennas
should always be located away from power lines.
DAMAGE REQUIRING SERVICE
This product should be serviced by qualified service personnel when:
 Objects have fallen, or liquid has been spilled into the product; or
 The product has been exposed to rain or moisture; or
 The product does not appear to operate normally or exhibits a marked change of
 performance; or
 The product has been dropped, or the cabinet damaged.
RF EXPOSURE
ATTENTION!
To satisfy FCC/IC RF exposure requirements, a separation distance specified in
Tables 1, 2, 3 or more should be maintained between the antenna of this device and
persons. To ensure compliance, operations at closer than this distance is not allowed.
RADIO OPERATOR
Futurecom requires the OCR operator to ensure FCC Requirements for Radio
Frequency Exposure are met. The minimum distance between all possible personnel
and the antenna must be as specified in Tables 1, 2 and 3.
FAILURE TO OBSERVE THE MPE DISTANCE EXCLUSION AREA AROUND THE
ANTENNA MAY EXPOSE PERSONS WITHIN THIS AREA TO RF ENERGY ABOVE THE FCC
EXPOSURE LIMIT FOR BYSTANDERS (GENERAL POPULATION). IT IS THE RESPONSIBILITY
OF THE OCR OPERATOR TO ENSURE THAT MPE LIMITS ARE OBSERVED AT ALL TIMES
DURING REPEATER TRANSMISSIONS. THE OCR OPERATOR MUST ENSURE AT ALL TIMES
THAT NO PERSON COMES WITHIN MPE DISTANCE FROM THE ANTENNA.
ATTENTION!
To satisfy FCC/IC RF exposure requirements, the OCR site operator must comply
with FCC/IC requirements for maximum site EIRP radiated power and antenna height
limits.