User's Manual
Table Of Contents
- About this document
- Safety Information
- General Radio Operating Procedures
- CMD Technical Description
- CMD Installation (19” rack mount only)
- CMD Programming
- CMD Front Panel Indicators
- CMD Specifications
Starting up the Programming Software
After connecting the programming cable to the CMD serial port, run the programming
software. Go to the Options pull down menu and select Ports. The following screen will be
Ensure that
displayed:
the correct communication port is selected and set the Baud rate to 9600 b/s. If
amming the CMD Frequencies of Operation
nter.
D EEPROM data and the
higher Baud rate is selected, ensure that the Baud rate scanning is set to Enable. Exit
from the Ports menu and select “Yes” when prompted “Would you like to update config
file?”
Progr
Go to File, select Upload Data from the CMD and press E
The programming software uploads the currently stored in the CM
CMD Channel Setup screen will be displayed:
8A074X06 Rev. Preliminary Page 11 of 15
21/08/2003