User Manual

遠瞻生活科技有限公司 WHDW Manual Guide
Future Life Technology Co., Ltd. 2019/09/03
Page 20 / 37
Ill 21：Main Screen
(2) Press the Enable button on both sides of the Wireless Manual Pulse Generator
(depending on the setting of the Enable button). At this time, the arrow on the
screen will change from hollow to solid arrow, indicating that both sides of
the Enable button are actually pressed, and the job can be started.
Ill 22：Main Screen
(3) Select the axis to be adjusted in X, Y, Z, 4~9, and press the touch button. At
this time, the corresponding button light is on, and the selected axis
coordinate is displayed on the screen. For example, if 8 is selected, the screen
is switched as follows.
Ill 23：Main Screen－8-Axis Coordinate
(4) Press the button of the magnification to select the magnification:
x1~x1000。
(5) Turn the handwheel, the hand-held end will transfer the value of the
handwheel to the charging stand, and convert it to pulse wave through the
charging stand to transmit to the machine.
Hibernation & Wake-up
When you don’t push any buttons on the Wireless Manual Pulse Generator for a
while, the screen will be dimmed and will go to sleep after a while. The standby time
is preset to 10 minutes at the factory.
When it go to sleep, the MPG, LED, touch buttons and screen will all be turned
off. To wake up again, press any Enable button on both sides. The emergency stop
button also wakes up the sleep state. The connection will not be interrupted by
dormancy, so if there is an emergency stop, it can react immediately.
Hand Free Function