Owner Manual

Safety Hard Cover
When a hot tub is uncovered, over 90% of heat is lost from the water surface. Safety Hard
Covers are designed for maximum thermal e$ciency. They are hinged in the middle for easier
handling, and the zip fastener allows the tapered foam inserts to be changed if damaged. The
skirt of the safety hard cover hangs over lip of the spa to protect the acrylic. The locks, with one
part fastened to the cabinet, prevent small children or animals from entering the hot tub. Do
not drag the safety hard cover across the hot tub or decking. Fold the cover first, then lift by
the handles. Safety Hard Covers are not designed to be stood or sat on. Standing on the hard-
cover could cause the foam inserts to crack, which will lead to water absorption.
NEVER SIT, LEAN OR STAND ON YOUR HARDCOVER.
Clean the Safety Hard Cover as needed with a cover cleaning product or saddle soap. Never
use cleaning products designed for the automotive or boating industry on a spa cover.
Troubleshooting
A good general rule is to visually inspect your spa and equipment area frequently. If anything
looks broken, worn, or incorrect, contact your electrician or spa dealer. A simple repair may
prevent an injury or more serious problems requiring expensive repairs. If your spa is not oper-
ating, check the following:
All equipment does not operate
• Check power source G.F.C.I. breaker.
• Check to assure spa has dedicated circuit.
• Check the “test” and “reset” buttons on G.F.C.I.
• Check internal fuses.
Pump does not work
• Check all items above.
• Check filter; clean or replace cartridge.
• Check for blockages (restrictions) at suctions, skimmer and pump basket.
• Push “jet” button to check if high speed is functioning on a dual-speed pump.
• Check if pump is plugged into spa pack
• Check for air lock (pump needs prime)
Inadequate jet action
• Make sure jets are turned on.
• Make sure air controls are open.
• Check for restrictions (blockages) in jets and/or main skimmer and pump basket.
• Check water level.
• Push “jet” button to check if high speed is functioning on a dual-speed pump.
• Check to be sure the optional Turbo diverter jet is in proper position.
No heat
• Check all steps under part “1.”
• Check for clogged filter element and other restrictions..
• Check water level.