User Manual

32
TROUBLESHOOTING
If your servo does not operate, it intermittently stops operating, or it operates
erroneously, take the action shown in the table below. If this does not correct the trouble,
please contact a Futaba dealer.
Table 0-1 Check list
Check point Check item Action
Battery Dead battery.
Incorrect loading voltage.
Replace the battery.
Charge the LiPo battery.
Reload the batteries in the correct polarity.
Change the recommanded battery
Connecter Faulty contact connection.
Dirty contacts.
If the contact pin is deformed, correct it.
Wipe with a dry cloth
Servo horn Looseness of screws Fasten the screws
Command ID, baud rate, check sum Conform the command packet rules
Cable Short-circuit Change the cable
Before requesting repair, read this instruction manual again and recheck your system.
Should the problem continue, request repair service as follows:
Describe the problem in as much detail as possible and send it with a detailed packing
list together with the parts that require service.
_Symptom (Including when the problem occurred)
_System(Application configuration)
_Model Numbers and Quantity
_Your Name, Address, e-mail address, and Telephone Number.
If you have any questions regarding this product, please consult your local Futaba dealer.