User Manual
Applicable systems: Futaba FASSTest-2.4GHz system
transmitter
R7008SB
FASSTest-2.4GHz Bidirectional Communication System
S.BUS2 / S.BUS Port and 8 Channels for Conventional System
Receiver
Compliance Information Statement
(for U.S.A.)
This device, trade name Futaba Corporation of America, model number
R7008SB, complies with part15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
(3) This module meets the requirements for a mobile device that may be used
at separation distances of more than 20cm from human body.
To meet the RF exposure requirements of the FCC this device shall not be co-
located with another transmitting device.
The responsible party of this device compliance is:
Futaba Service Center
3002 N Apollo Drive Suite 1, Champaign, IL 61822 U.S.A.
TEL (217)398-8970 or E-mail: support@futaba-rc.com (Support)
56%6SHFLÀFDWLRQV
FASSTest-2.4GHz system(18CH/12CH mode)/S.BUS2 and S.BUS port
and 8 channels for conventional system receiver
'XDODQWHQQDGLYHUVLW\
6L]H[[LQ[[PP
:HLJKWR]J
3RZHUUHTXLUHPHQW9WR99ROWDJHUDQJHWR9
%DWWHU\)69ROWDJH,WVHWVXSZLWKDWUDQVPLWWHU
([WUD9ROWDJHSRUW
∼
9'&
%HVXUHWKDWZKHQXVLQJ(6&VUHJXODWHGRXWSXWWKHFDSDFLW\RIWKH(6&PXVW
PHHW\RXUXVDJHFRQGLWLRQ
Thank you for purchasing a Futaba R7008SB FASSTest-2.4GHz compatible receiver.
The R7008SB receiver features bi-directional communication
with a FASSTest Futaba transmitter using the S.Bus2 port. Using the S.Bus2 port an impressive array of telemetry sensors may be utilized. It also
includes both standard PWM output ports and S.Bus output ports.
LED Indication
Green Red Status
Off Solid No signal reception
Solid Off Receiving signals
Alternate blink Unrecoverable error (EEPROM, etc.)
(Antenna installation)
90˚
Please refer the table below for LED status vs
receiver's condition.
01
6%86
SRUW
6%86SRUW 6%ك
6%86ك
56%
7HUPLQDOER[
6%866HUYR
6%86*\UR
+8%
+8%
+8%
+8%
([WUD9ROWDJH
3RUW
/LQN0RGHVZLWFK
$QWHQQD
/('
6HUYRIRU FRQYHQWLRQDO
V\VWHP
&KDQQHORXWSXW
&KDQQHORXWSXW
7HPSHUDWXUH
6HQVRU
530
6HQVRU
9ROWDJH
6HQVRU
9ROWDJH
6HQVRU
$OWLWXGH
6HQVRU
$OWLWXGH
6HQVRU
6%867RRO
%DWWHU\WR%
,WLVQRWXVHGIRUDOLQN
+
−
It connects with the
battery for power, etc.
External voltage input
cable of an option is
used. The voltage of
the battery can be
displayed with a
transmitter.
Usage precaution
12CH mode.
transmitters.
WARNING
-
cuits.
Antenna installation precaution
Antenna installation for carbon fuselage
WARNING
-
(Typical installation)