7PX Manual

94
Function
Use PS1 to PS6 to switch the A.B.S. function ON/OFF.
See the switch select function. (page 69)
Switch setting
The brake return amount, delay amount and cycle speed can be controlled with digital
trim DT1 to DT6 or digital dial DL1 etc. with the dial select function. (page 66)
Dial / Trim Setting
Brake return: Approx. 30% (If this value is too high, the braking distance will increase.)
Cycle speed: 5~7
Duty ratio: 0 (When grip is low: - side, when grip is high: + side)
Delay : 10~15%
Trigger point: Approx. 70%
Steering mixing: Off
- When the wheels lock, or the car spins, when the brakes are applied fully
Brake return: Increase from 30%
Duty ratio: Shift from 0 to - side (-1, -2, -3, -4)
Delay : Reduce the delay
- When the braking effect is poor and the braking distance is long when the brakes are
applied fully
Brake return: Decrease from 30%
Duty ratio: Shift from 0 to + side (+1, +2, +3, +4)
DLY: Increase the delay
Example of A.B.S. function setting when S9373SV used
(There will be a slight difference depending on the state of the linkage.)
A.B.S