7PX Manual

63
Function
Neutral brake "Rate"
Trigger
(Preparation)
- Use the switch select function to the "Switch select". (page 69)
When the switch is not set "A switch is not assigned" is dis-
played. Tap [Switch select] to display the switch selection screen
and set the switch.
1
(Neutral brake rate)
Tap the value button of the [Rate]. Value input
buttons appear on the screen and use the
[+] and [-] buttons to adjust the neutral brake
rate amount.
Neutral Brake function adjustment
Adjust button
Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Neutral Brake
0~100
Initial value: 0
2
When fi nished, return to the Linkage menu screen by pressing the HOME button.
Warning display
If the power switch is
turned on while the neu-
tral brake switch is on,
an audible alarm will be
heard. Immediately set
the neutral brake switch
to OFF.
Neutral brake ON/OFF is indi-
cated on the home screen for a
few seconds.
It is displayed in the home
screen, when the neutral brake is
ON.
When the neutral brake is ON,
the display of the throttle trim on
the home screen becomes the
neutral brake.
The ESC neutral brake function and T7PX neutral brake function can be used simulta-
QHRXVO\+RZHYHUZKHQVHWWLQJLVGLI¿FXOWWRXQGHUVWDQGZHUHFRPPHQGWKDWRQO\RQH
neutral brake function be used.
Reference
When the neutral brake function is
"
ON
"
, the neutral brake rate adjustment is automati-
cally assigned to the throttle trim (DT1 to DT6 or DL1).
Dial / Trim Setting
Throttle side EPA function, or ATL function setting also affects neutral brake side op-
eration. The Idle-up (page 72) or Engine Cut (page 101) function has priority.
Effect of set value of other functions on neutral brake