7PX Manual

Brake 2 Brake 3 Brake 2&3
61
Function
Acceleration
(Preparation)
- Tap the value button of the [Forward]. Value input buttons appear
on the screen and make the following adjustments:
1
(Forward acceleration amount adjustment)
Use the [+] and [-] buttons to adjust the ac-
celeration amount.
"0" :No acceleration
"100" : Maximum acceleration (Approximately 1/2 of the for-
ward side throttle angle)
Throttle acceleration adjustment
The throttle acceleration adjustment amount (Forward), (Brake 1), auxiliary channels
(Brake 2, Brake 3) can be controlled with digital trim DT1-DT6 or digital dial DL1 etc.
with the dial select function. (page 66)
Dial / Trim Setting
Adjustment buttons
Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Forward acceleration amount
(Forward)
0~100
Initial value: 0
Brake side acceleration amount
(Brake1)
0~100
Initial value: 0
When Trigger Ratio (page 62) was set to 100:0, brake operation is stopped and the throt-
tle (brake side) cannot be adjusted.
Caution
2
(Brake side acceleration amount adjustment)
Tap the travel button of the [Brake 1]. Value
input buttons appear on the screen and use
the [+] and [-] buttons to adjust the accelera-
tion amount.
"0" :No acceleration
"100" :Maximum acceleration (Brake side maximum
throttle angle)
If the "Brake Mixing Function" (page 106) is
being set, the auxiliary channel brake side
acceleration will become adjustable.
3
When finished, return to the Linkage menu screen by pressing the HOME button.