7PX Manual

HOME Menu Linkage menu Receiver
* Even with the same receiver,
if you change the system, be
sure to link with the receiver
and power cycle the receiver.
(page 38 to 39)
S-FHSS/FASST T-FHSS T-FHSS SR
37
Initial Set-Up
Receiver system Change & How To Link
)LUVWVHWXSWKHUHFHLYHU6HWWLQJFKDQJHVDUHLPPHGLDWHO\UHÀHFWHG 1H[W WKH WUDQVPLWWHU
and receiver are linked and the receiver memorizes the transmitter ID number so that sig
-
nals from other transmitters will not be received.
In addition, with the T-FHSS telemetry system, the transmitter simultaneously memorizes
the receiver ID numbers so that data from other receivers will not be received.
The method of setting up the receiver system and the method of linking the transmitter and
UHFHLYHUDUHGHVFULEHG5HIHUWRWKH¿JXUHDWWKHULJKWIRUWKHHGLWEXWWRQVXVHG
1
Set the transmitter "PWR" side power switch to ON. From the Home screen, press the
HOME button or tapped [Menu] on the touch panel. Next, select [Receiver] at the Linkage
menu and access the setup screen shown below by tapping the screen.
2
In "Receiver", select and tap the system to be set from T-FHSS SR, T-FHSS, S-FHSS,
FASST. The confirmation screen will be displayed. To execute, tap [Yes] to hear an electronic
sound and finish setting. To cancel, select [No] and touch it. If you change the system, be
sure to link it with the receiver and turn the power on again.