7PX Manual

Home screen

Menu screen System menu screen

Calibration

184

Function

Calibration

Steering and throttle correction can be applied. Use this function when a mechanical offset

has occurred for some reason.

Calibration

However, if correction was applied, it may be necessary to recheck the set values of all

the setup functions.

(Preparation)

Tap the [Wheel]. The neutral correction screen appears.

(Steering neutral adjustment)

At neutral, turn the steering wheel left and right. Press the

[Neutral] button while the steering wheel is in its neutral posi-

tion. If the [Neutral] position is OK, the [End Point] button will

appear after pressing the [Neutral] button. If not within the

correction range, the [End Point] button will not appear.

(Steering wheel travel adjustment)

With [End Point], slowly rotate the steering wheel left and

right, tap the [End Point] button. If the [End Point] correction is

OK, the display will return to the calibration screen. If the end

point is not within the correction range, the display does not

return to the adjuster screen. In this case, return to the sys-

tem menu screen by pressing the HOME button. If operation

cannot be ended normally even when correction is repeated,

please contact the Futaba Service Center.

Steering adjustment

When ﬁnished, return to the System menu screen by pressing the HOME button.