7PX Manual

Communication port.

Cover

165

Function

Sensor

Sensor Reload

When using multiple sensors of the same type the sensors must be registered in the trans-

PLWWHU&RQQHFWDOOWKHVHQVRUVWREHXVHGWRWKH73;DVVKRZQLQWKH¿JXUHEHORZDQGUHJ

ister them by the following procedure. The ID of each sensor is registered in the transmitter.

To load the sensor, connect all sensors to be used to the T7PX communication port as

shown below. Power supply is unnecessary. Also, to clear all sensor registration, execute

this [Reload] function without connecting sensor. The registration is cleared and all the

slots in the sensor list are unregistered.

All the sensors to be used

are connected to the

T7PX.

Sensor

(Start slot selection)

Tap the [Reload], The conﬁ rmation screen will be displayed. To execute, tap [Yes] to hear an

electronic sound and ﬁ nish setting. To cancel, select [No] and tap it. If "Success" appears on

the screen, reload is complete.

When ﬁ nished, return to the Telemetry screen by pressing the HOME button.

How to change start slot and set empty slot