10PX Transmitter - Manual

80
Returntotableofcontents
Linkage menu
L
R
DT1
The number of channels varies de-
pending on the selected system.
Tap to change page
(Preparation)
- Before setup of the steering end point adjustment, set the steer-
ing D/R dial (initial setup: DT5) to the maximum steering angle
position 100%.
- Tap the travel button of the [Steering Left]. Value input buttons
appear on the screen and make the following adjustments:
1
Steering (left side) adjustment.
Turn the steering wheel entirely to the left and use
the [+] or [-] buttons to adjust the steering angle.
Steering end point adjustment
Quick EPA
When EPA trim is turned on, the steering angle (end point) can be adjusted
by steering trim set digital trim or dial. (Steering trim initial setting: DT1)
With the steering wheel turned
fully to the right, steering is ad-
justed by steering trim and tem-
porarily displayed at this part of
the HOME screen, as shown in
the figure below.
-Steering right side adjustment
With the steering wheel turned
fully to the left, steering is adjust-
ed by steering trim and temporar-
ily displayed at this part of the
HOME screen, as shown in the
figure below.
-Steering left side adjustment
2
Steering (right side) adjustment.
Turn the steering wheel entirely to the right and
use the [+] or [-] buttons to adjust the steering
angle.
Note
Step #1 & #2 are done when the receiver is in the on position installed on
the chassis. You’re watching the wheels reach their maximum end point.
3
When finished, return to the Linkage menu screen by press-
ing the HOME button.
Adjustment buttons
Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons .
Steering End point: 0~140
Initial value: 100
LINKAGE MENU
Home screen Menu screen
Menu-1 Menu-2
End point
Linkage menu screen