10PX Transmitter - Manual

76
Returntotableofcontents
LINKAGE MENU
Neutral brake "Rate"
(Preparation)
- Use the switch select function to the "Switch select".
When the switch is not set, "A switch is not assigned" is
displayed. Tap [Switch select] to display the switch selec-
tion screen and set the switch.
1
(Neutral brake rate)
Tap the value button of the [Rate]. Value
input buttons appear on the screen and
use the [+] and [-] buttons to adjust the
neutral brake rate amount.
Neutral Brake function adjustment
Adjust button
Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Neutral Brake
0~100
Initial value: 0
2
When finished, return to the Linkage menu screen by pressing the HOME button.
Warning display
If the power switch is
turned on while the
neutral brake switch is
on, an audible alarm
will be heard. Imme-
diately set the neutral
brake switch to OFF.
It is displayed on the home
screen when the neutral brake is
ON.
When the neutral brake is ON,
the display of the throttle trim on
the home screen becomes the
neutral brake.
The ESC neutral brake function and the T10PX neutral brake function can be used
VLPXOWDQHRXVO\+RZHYHUZKHQWKHVHWWLQJLVGL൶FXOWWRXQGHUVWDQGZHUHFRPPHQG
that only one neutral brake function be used.
Reference
When the neutral brake function is
"
ON
"
, the neutral brake rate adjustment is auto-
matically assigned to the throttle trim (DT1 to DT6 or DL1).
Trim/Dial Setting
7KURWWOHVLGH(3$IXQFWLRQRU$7/IXQFWLRQVHWWLQJDOVRD൵HFWVQHXWUDOEUDNHVLGH
operation. The Idle-up or Engine Cut function has priority.
Effect of set value of other functions on the neutral brake