10PX Transmitter - Manual

58
Returntotableofcontents
SYSTEMMENU
Steering and throttle correction can be applied. Use this function when a mechanical
R൵VHWKDVRFFXUUHGIRUVRPHUHDVRQ
Calibration
However, if correction was applied, it may be necessary to recheck the set values of
all the setup functions.
(Preparation)
Tap the [Wheel]. The neutral correction screen appears.
1
(Steering neutral adjustment)
At neutral, turn the steering wheel left and right. Press the
[Neutral] button while the steering wheel is in its neutral posi-
tion. If the [Neutral] position is OK, the [End Point] button will
appear after pressing the [Neutral] button. If not within the
correction range, the [End Point] button will not appear.
2
(Steering wheel travel adjustment)
With [End Point], slowly rotate the steering wheel left and
right, tap the [End Point] button. If the [End Point] correction
is OK, the display will return to the calibration screen. If the
end point is not within the correction range, the display does
not return to the calibration screen. In this case, return to the
system menu screen by pressing the HOME button. If the op-
eration cannot usually be ended even when correction is re-
peated, please contact the Futaba Service Center.
Steering adjustment
3
When finished, return to the System menu screen by pressing the HOME button.
Home screen Menu screen
Menu-1 Menu-2
Calibration
System menu screen