10PX Transmitter - Manual

40
Returntotableofcontents
Throttle mode
Forward 50: Brake 50
Forward 60: Brake 40
Forward 70: Brake 30
Forward 100: Brake 0
Forward 50: Brake 50 Forward 60: Brake 40 Forward 70: Brake 30 Forward 100: Brake 0
50 : 50 60 : 40
70 : 30 100 : 0
Throttle trim (DT2) Steering trim (DT1)
Steering trim
Throttle trim
Throttle Ratio Check
-The throttle servo travel can be set to 50:50, 60:40, 70:30, or 100:0 for throttle trig-
ger operation as required by the Throttle mode (in the Linkage menu).
-The throttle brake operation might be close by setting it to
"
100:0
"
when the T10PX
transmitter with the boat is used.
Trims Initial Set-Up
- Steering trim (DT1) check
On the initial set-up, the steering trim is assigned to the DT1 trim lever above. Op-
erate the lever and make sure the marker moves on the ST graph. If the default has
been changed, test steering trim in its new location. After checking the trim, set the
trim display to the center (N) position.
- Throttle trim (DT2) check
On the initial set-up, the throttle trim is assigned to the DT2 trim lever. Operate
the lever and make sure the marker moves on the TH graph. If the default has been
changed, test the throttle trim in its new location. After checking the trim, set the
trim display to the center (N) position.