10PX Transmitter - Manual

38
Returntotableofcontents
No signal reception Red: On
Receiving signals Green: On
Receiving signals, but ID is unmatched. Green: Blink
*1
(T-FHSS, Red: On)
Unrecoverable failure (EEPROM,etc.) LED: Red and Green turn on alternately
*1: LED could be changed to red during intermittently during data processing.
S-FHSS/FASST Receiver Link
1
Bring the transmitter and the receiver close to each other,
within 20 inches (half meter).
2
Turn on the power switch (PWR). On the display (DSP) side,
you cannot link.
3
Turn on the receiver.
4
Push the push switch of the receiver.
When the link is complete, the LED in the receiver changes to solid green. Check the
operation of the servo.
Precaution:
If there are many Futaba 2.4GHz systems turned on close to your receiver might not link to your transmitter. In this case,
even if the receiver’s LED stays solid green, unfortunately, the receiver might have established a link to one of the other
transmitters. It is dangerous if you do not notice this situation. To avoid problems, it is strongly recommended that you
double-check that the transmitter controls the receiver by making the wheel or trigger inputs and checking the servo re-
sponse.
*Please refer to the table below for LED status vs receiver's condition.
LED status vs receiver’s condition:
*The T10PX and F-4G receiver (R404SBS/R404SBS-E)/T-FHSS receiver memorize the IDs linked last at each model mem-
ory. Since only one receiver ID is memorized at each model memory, multiple F-4G/T-FHSS receivers cannot be used with
the same model memory. When a receiver at the same model memory is changed, re-linking is necessary even if the receiv-
er is already linked with the transmitter.
*When using multiple F-4G/T-FHSS receivers, link each receiver with each T10PX model memory. However, one receiver
can be linked with multiple model memories.
*The telemetry function communication status can be checked at the T10PX home screen.
)RURWKHUWKDQ)*V\VWHPWKHOLQNSURFHGXUHLVGL൵HUHQW
Linknotice
WARNING
Donotperformthelinkingprocedurewithmotor'smainwireconnectedas
itmayresultinseriousinjury.
Afterthelinkingisdone,pleasecyclereceiverpowerandcheckifthereceiver
tobelinkedisreallyunderthecontrolofthetransmittertobelinked.
■ Thesettingswillnotbereflectedunlessrestart.