10PX Transmitter - Manual

31
Returntotableofcontents
R404SBS R404SBS-E
Warning
Install the antenna in the higher place as shown in the figure.
Do not cut or bundle the receiver antenna wire. (R404SBS)
Do not bend the coaxial cable. It causes damage. (R404SBS)
Do not pull the receiver antenna or coaxial cable by force. (R404SBS)
Keep the antenna as far away from the motor, ESC and other noise sources as you possibly can.
Wrap the receiver with something soft, such as foam rubber, to avoid vibration. If there is a chance of
getting wet, put the receiver in a waterproof bag or balloon.
Antenna
Antenna
R404SBS-E
Antenna Antenna
Coaxial cable
Link switch/LED
Link switch/LED
Connectors
"
4
"
:CH4 servo(CH4)
"
3
"
:CH3 servo(CH3)
"
2
"
:Throttle servo/ESC(CH2)
"
1
"
:Steering servo(CH1)
"
S
"：CH5~CH10S.BUS2servos
Telemetrysensors
The receiver power supply can be con-
nected to the S.BUS2 connector or each
of CH1-4.
Receiver Installation
Install the receiver on the car as follows:
NOTE: The operating range may reduced, depending on where the receiver and the an-
tenna are mounted.
NOTE: Put the antenna in the antenna tube to protect it. Do not let the tip go outside.
(R404SBS)
NOTE: It is a receiver of diversity type with both external and internal antennas. Do not
place wiring or other objects on the plate. The receiving range may be affected.
Receiver Terminology
Caution
Always use R404SBS
（-
E
）
under the following conditions:
Battery :Power requirement Rated voltage 3.7 to 7.4 V (dry cell battery cannot be used)
Matched to the ratings of the receiver and connected servo.
• Transmitter’s receiver system > F-4G
• Use the servo that matches the servo type of each receiver response.
Under other conditions, the set will not operate, or the specified performance will not be displayed even if it operates. In addi-
tion, it may cause trouble with servos and other equipment. Futaba will not be responsible for damage, etc. caused by combi-
nation with the products of other companies.
R404SBS
Antenna
Coaxial cable
Antenna tube
Do not install the receiver as
shown on the left.
Do not put decals or double-
sided tape on the antenna.
NEVER use the R404SBS-E in
GP(Engine) cars.
forEPCarModels