10PX Transmitter - Manual

25
Returntotableofcontents
9
Attach the wheel unit to the APA with
four M2×19 screws.
11
Attach the assembled steering unit
to the body with two M3x12 screws.
(Using a hex wrench.)
8
Fit the rear cover and attach the APA to
the steering housing with three M2x10
screws and one M2x6 screw.
M2×6
Rear cover
*The rear cover depends on the size of the APA.
Wheel unit
M3×12
M2×10
M2×19
APA uses the inside holes. The mounting angle in
the direction of rotation can be adjusted.
Normal
screw
position
Adjust the angle with the position mark.
APA
Steering housing
10
Install the assembled steering unit to
the transmitter body.
- From left to right, the
order is 2 pin connec-
tor, 15 pin connector,
4 pin connector.
- Use the accessory screws and the
transmitter screws.
-There are extra screws in the accesso-
ries.
APA
Adjust the angle with the position mark.
12
Insert the wheel and hold the wheel
and attach the screw.
(Using a hex wrench.)
M2×10
M2×10
M3×12
2 pin 4 pin
- Install slowly so that
the wiring is not
pinched.
- Do not overtighten these four screws.