10PX Transmitter - Manual

21
Returntotableofcontents
Do not charge the Lipo battery from the charging port on the top
back of the transmitter
There is a risk of explosion or fire, which is very dangerous.
Warning
Do not charge the Lipo battery with LBC-34/38D P or ICS LF-01.
There is a risk of explosion or fire, which is very dangerous.
Temperature protection for battery charge : LT2F2000B
Temperature
Lowtemp.protection 0 ± 5° C
Hightemp.protection 45 ± 5° C
●
LiPo battery installation
Install the Lipo spacer on the transmitter
and then the Lipo battery.
●
Battery type change
Be sure to change to LiPo battery type
in System Menu
→
Battery
Be sure to do it when using LiPo.
●
Charging LED
Lights red while charging. When charging
is complete, it lights up in green.
When Charging For The Optional LiPo Battery
To charge the battery, connect a type C USB cable to the Futaba optional USB AC adapter or a commercially
available USB AC adapter (USB-A type 5 V-2 A) from the Lipo dedicated charging port.
ChargingLED
Red:Charging
Green:Full
Useacommercially
availableUSBcharger
ACadapter
USB-Atype5V-2A
USBCable
Battery charging port
LiPo Battery charging port
Lipo spacer
DonotchargetheLipo
batteryfromhere ！
LED
Attention to the direction!
Battery charging port, LED
on this side.
Lipo Battery LT2F2000B Replacement Method
Connect to the connector
on this side.
Store the battery wiring in
this groove.