10PX Transmitter - Manual

198
Returntotableofcontents
ACCESSORYMENU
If "Failed" is displayed on the screen, communication
with the gyro has not been performed normally.
Check receiver, gyro and battery connections,
transmitter and receiver power switches, and repeat
reading.
When not using S.BUS connection,
select [Wireless 1 (receiver Ch1)]
* When the S.BUS connection is
not used, the gyro data switching
function cannot be used, so only
[Gyro data 1] is displayed.
When using S.BUS connection,
select [Wireless (receiver S.BUS2)]
Connect the power
supply of the receiver.
Connect the power
supply of the receiver.
Receiver
Gyro gain CH3
Steering servo
Steering CH1
Steering servo
S.BUS Receiver
S.BUS/S.BUS2 port
*
Do not use the Gn
2
(Writing to Gyro)
Execute this function to write the setting data to
the Gyro.
Tap the setting item [Write] on both the Basic set-
ting screen and the Gyro data screen.
After "Read
Please wait" is displayed, an electronic sounds
and writing ends. Be sure to write after changing
the settings.
- If "Failed" is displayed on the screen, communication with
the gyro has not been performed normally. Check receiver,
gyro and battery connections, transmitter and receiver
power switches, and repeat [Write].
- Refer to "Setting method of each item" for the contents of
the setting data.
3
(Initialization)
Write the factory set Gyro setting data to the connected the Gyro.
Tap [Reset] on the gyro reading screen; the confirmation screen
will be displayed. To execute, tap [Yes] to hear an electronic
sound and finish setting. To cancel, select [No] and tap it.
- If "Failed" is displayed on the screen, communication with the gyro has not been
performed normally. Check receiver, gyro and battery connections, transmitter
and receiver power switches, and repeat [Reset].
Gyro reading screen
Example
:
Basic setting screen