10PX Transmitter - Manual

197
Returntotableofcontents
ACCESSORYMENU
Gyro Link
Home screen
Menu screen
Accessory menu screen
Gyro link
The Gyro Link is a function that allows you to set the parameters of the car gyro wire-
lessly from the transmitter.
*A gyro compatible with the wireless setting
:
GYD550 (As of Dec. 2021)
 8SWR¿YHSUHVHWVFDQEHVZLWFKHGZKLOHGULYLQJ*\URGDWDVZLWFKLQJIXQFWLRQ
- The S.BUS servo data can be set wirelessly from the transmitter via the gyro.
*A receiver compatible with the wireless setting function is required. (As of Dec. 2021, R404SBS/
R404SBS-E/R334SBS-ver. 4.0 or later / R334SBS-E-ver. 4.0 or later)
* While using Gyro Link wireless SBUS servo adjustment will not function.
- To be able to control gyro gain, etc. from the transmitter, it is necessary to enable the
J\URPL[LQJIXQFWLRQRIWKHWUDQVPLWWHU
- In the wireless setting, reading / writing / reset / initialization may take a long time or
may fail depending on the surrounding radio wave environment. If it fails, try again.
(Preparation)
- Connect the receiver and gyro according to the connection diagram below.
* The connection diagram is a reference diagram for selecting the gyro link connection method. Please read the
gyro instructions for details or cautions.
- Turn on the power switch PWR of the transmitter to display the Gyro Link screen.
* Note that this cannot be used with the display switch DSP.
- Turn on the receiver power switch.
1
(Gyro read)
When you open the Gyro Link screen from the Accessory menu or Custom menu, the con-
nection method selection screen is displayed. Tap the button according to the connection
method between the gyro and the receiver.
The Gyro type and currently set contents are read.
Using the Gyro Link function