10PX Transmitter - Manual
Table Of Contents
185
Returntotableofcontents
1
The type and data of the loaded servo are displayed. Since there are two setting items,
change the page as follows.
1
(Writing to the servo)
Tap the [SR mode] or [Normal mode] of the
SR mode setting. A confirmation screen of
"Notes on SR setting" is displayed, so read
carefully and tap [Normal mode] or [SR
mode].
- When [Normal mode] is selected, "Writing succeeded"
is displayed on the screen, and the setting data is writ-
ten to the servo.
- If "Failed" is displayed, communication with the servo is
not performed usually. Check the connection between the T10PX and the servo, and then execute the write oper-
ation again.
2
(When SR mode is selected by writing to the servo)
In the confirmation screen of "Notes on SR setting", tap
[SR mode], the screen for selecting the SR type is dis-
played. Three different SR modes are prepared. (Please
repeat the test and choose the type. )
- "Writing succeeded" is displayed on the screen, and the setting data
is written to the servo. If "Failed" is displayed, communication with
the servo is not performed usually. Check the connection between the T10PX and the
servo, and then execute the [Write] operation again.
- For the servo set to SR mode, affix the supplied SR label so that SR mode can be reconized.
Display data list
SR mode setting (Wired only)
When the connected servo
type is not compatible with
the SR mode, "Unsup-
ported Normal mode" is
displayed
- Do not plug in or disconnect servos, or connect other servos while keeping the
screen where data was read by [Read]. Be sure to connect the servo in the state
ZKHUH>:ULWH@RU>5HVHW@LV¿QLVKHGRUSUHVVWKH+20(EXWWRQWRDFFHVVWKHDF-
cessory menu screen.
- The loaded data cannot be written to another servo.
e
d
.
The type of servo and
the set SR type are dis-
played.
Do not connect any servos that are on SR mode to a receiver via
S.BUS/S.BUS2 terminal. You cannot use an SR servo in the SBUS/
S.BUS2 ports, as they are not compatible with SR mode. The SR
servo can be damaged if it is connected to the S.BUS/S.BUS2 ports.
ACCESSORYMENU