10PX Transmitter - Manual

183
Returntotableofcontents
- Reference
When using "S.BUS/S.BUS2" servo with
steering mixing (Mixing menu) with a twin
servo specification car such as 1/5 GP car,
in the channel setting function (Linkage
menu), the 1st channel and 2nd channel
are set to steering, both servos can be
wirelessly set.
Communication port.
Connecting S.BUS/S.BUS2
servo connector to the trans-
mitter Communication port.
Cover
Wireless 2 (Rx Ch2)
Wireless 1 (Rx Ch1)
Servos connected to Ch3/
Ch4 of the receiver cannot
be set wirelessly.
Home screen
Menu screen
Accessory menu screen
S.Bus servo
(Preparation)
-Connect S.BUS or S.BUS2 servo with reference to the above connection diagram.
-Connect the battery to a non-high voltage (HV) support S.BUS/S.BUS2 servo.
-Be sure to use the wired method when changing the setting of SR mode. Mode cannot be
changed with the wireless setting.
1
If it is wired, turn on the power switch DSP or PWR of the transmitter.
In the case of wireless, turn on the PWR side of the power switch. Wireless settings cannot
be used on the DSP side. Turn on the battery switch of the receiver and check the operation
of the servo. The S.BUS servo screen is displayed.
Using the S.BUS servo function
Connection between wired transmitter and servo
The connection between the wireless receiver and servo
ACCESSORYMENU