10PX Transmitter - Manual
Table Of Contents
182
Returntotableofcontents
This function is a unique function that allows the Futaba S.BUS/S.BUS2 servo param-
eter changes to be set by the T10PX transmitter. However, some data changes require
a PC and S-Link software. There are two ways to set Futaba S.BUS/S.BUS 2 servo
directly by connecting it to the communication port of the transmitter and wirelessly
setting it with the servo still connected to the receiver. When setting with wires, please
XVHDQRSWLRQDOH[WHQVLRQFRUGIRUVHUYRDVQHFHVVDU\65PRGHVHWWLQJLVIRU73;
only, it cannot be set with S-Link software.) Also, there are restrictions on wireless set-
tings, so read the following
"
Notes
"
below.
S.BUS Servo
,IVKXWWLQJ R൵ WKHWUDQVPLWWHU ZKLOHWKHSDUDPHWHUV WKHVHUYRPD\IDLO3OHDVHXVHWKLV
IXQFWLRQZLWKVX൶FLHQWEDWWHU\SRZHU
- For safety reasons, it is not possible to change between normal mode and SR mode with
the wireless setting. To change the mode, connect the servo to the communication port
and switch. However, for servos set to SR mode, SR1/SR2/SR3 can be switched by wire-
less setting.
- Wireless settings cannot be used if a device that converts signals such as gyro and FSU
(Failsafe Unit) etc. are connected between the receiver and the servo.
-A receiver compatible with the wireless setting function is required. As of Sep. 2021,
R404SBS/R404SBS-E/R334SBS(version 2.0 or later.)/R334SBS-E(version 2.0 or later.) is
compatible with wireless setting.
-Power is supplied to the servo from the transmitter, but the corresponding voltage is for
high voltage servo (HV) use. Since an overvoltage will be applied to servos other than
this, connect the corresponding battery to the servo. When the battery is connected, the
supply of power from the transmitter automatically stops.
-In the wireless setting, reading / writing / reset / initialization may take a long time or
may fail depending on the surrounding radio wave environment. If it fails, try again.
WARNING
In the wireless setting, there is a danger that a car (boat) can become unexpectedly
uncontrollable, because the servo temporarily stops working during communication. For
safety, in case of electric car (boat), please set with driving wheel (boat propeller) not
touching the road surface (water surface). Also, in the case of an internal combustion
engine car (boat), be sure to stop the engine before entering wireless set-up mode.
CAUTION
When connecting an S-BUS servo that does not support high voltage, connect a battery
matched to the servo specifications.
High voltage servo support voltage is supplied from the transmitter. If a servo that does not support high voltage is connected, unrea-
sonable force will be applied to the servo and will cause trouble.
Do not disconnect the servo connector or turn off the transmitter power while writing
parameters.
It may cause the servo to malfunction.
ACCESSORYMENU