10PX Transmitter - Manual
Table Of Contents
175
Returntotableofcontents
Lap timer function
Lap timer function
- The lap timer can memorize each lap time of each switch operation. (200 laps)
- The race time can be set. Switch operation after the set time my
alarm has elapsed automatically stops the timer. Pre-alarm can
also be set. The passage of time is announced by the sounding of a
buzzer (beeps) each minute after starting.
-Alarm: Generates a beep at the set time.
Pre-alarm: Starts sounding the set time (second) before the alarm. (beeps)
7KH¿UVWVWDUWRSHUDWLRQFDQEHOLQNHGZLWKWKHWKURWWOHWULJJHU
(Lap timer operation)
- When lap timer is selected, the number of laps (Lap) and the and current lap time
are displayed on the setup screen.
* LAP: Counted up each time the switch is pressed after starting. After the switch is pressed, the lap time
display will pause for 3-seconds. Switch operations are not accepted at this time to prevent accidentally re-
counting.
* Lap memory: The lamp memory saves the lap times of 200 laps.
* The lap time data stored in the lap memory can be checked at the lap list screen.
Lap navigate timer function
Lap navigate timer function
7KLV IXQFWLRQ VRXQGV OLNH D EX]]HU DW D ¿[HG LQWHUYDO DIWHU WKH
timer starts. Since only the buzzer can be restarted when the
switch is pressed during timer operation, this function can be used
as the training run, etc. target time. (Lap navigation alarm) The
passage of time is announced by the sounding of a buzzer (beeps)
every minute after starting.
7KH¿UVWVWDUWRSHUDWLRQFDQEHOLQNHGZLWKWKHWKURWWOHWULJJHU
- The alarm sounds (Alarm/Pre-alarm) can be set separately from
WKH¿[HGLQWHUYDOEX]]HU
- Alarm: Generates a beep at the set time (minutes).
- Pre-alarm: Alarm advance announcement sound. Sounding begins 10-seconds before the set alarm time.
- After starting, the timer is enabled and can be stopped by switch even when the
display switches to another screen.
ACCESSORYMENU