10PX Transmitter - Manual

160
Returntotableofcontents
TELEMETRYMENU
Adjustment buttons
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Telemetry: RPM
Speed information from an SBS-01RM (telemetry rotation sensor) sold separately is
displayed and set at this screen. The speed of the engine, motor, etc. of the chassis
while running can be viewed at the transmitter. When the speed becomes higher (lower)
than the set speed, it can be announced by an alarm and vibration.
* A RPM sensor must be installed in the model car. Install and connect the sensor following the sensor instruction
manual.
Telemetry
Current RPM
The Speech function (ON/OFF)
The maximum when powering
ON are shown.
Gear ratio
Sets the limit speed
Upper limit/lower limit
(Speed that sound an alarm)
Alarm and vibrator ON/OFF and
type setting (The
arrow indicates
that an alarm is generated when the
speed drops below the set value and
the arrow indicates that an alarm is
generated when the speed exceeds
the set value.)
1
(Gear ratio adjustment)
Tap the [Gear ratio]. Value input buttons appear on the
screen.
Use the [+] or [-] button to adjust the Gear ratio.
2
(Limit adjustment)
Tap the "
" [
Limit] or "
" [
Limit]. Value input buttons appear on the screen.
Use the [+] or [-] button to adjust the limit value.
3
(Alarm and vibrator function setup)
Tap the "
"/
"
"
[Alarm] type and select [Inhibit], [Buzzer]or [Voice].
"Inhibit": No audible alarm/ "Buzzer": Audible alarm/ "Voice": Voice alarm
Tap the "
"/
"
"
[Vibrator] type and select [Inhibit], [Type 1], [Type 2], or [Type 3].
"Inhibit": No active vibration
"Type 1": Continuous vibration
"Type 2": Intermittent vibration for a long time
"Type 3": Intermittent vibration for a short time
4
(Speech function setup)
Tap the "Voice" (ON) or (OFF) to select ON/OFF.
"OFF": No voice guide
"ON": Information loaded by voice
5
When finished, return to the Telemetry screen by pressing the HOME button.
Alarm and Vibrator function setup
*The voice guide loading inter-
val is set by sensor menu.