10PX Transmitter - Manual

15
Returntotableofcontents
Adjust within the range
of the mark.
Wheel tension
adjusting screw
Trigger tension ad-
justing screw
Wheel & Trigger Tension Adjustment
0DNHWKLVDGMXVWPHQWZKHQ\RXZDQWWRFKDQJHWKHZKHHORUWULJJHUVSULQJ¶VWHQVLRQ
Adjustment
1
Using hex wrench, adjust the wheel
spring tension by turning the screw in-
side the adjusting hole.
- The spring is set to the weakest ten-
sion at the factory.
- When the adjusting screw is turned
clockwise, the spring tension increas-
es.
Note:
The adjustment range is up to 7 to 8 turns from the fully tightened (strongest) posi-
tion. If turned farther than this, the adjusting screw may fall out.
Trigger mounting
screw
Adjustment
1
Using a hex wrench, loosen the trigger slide mounting screw by turning it slightly coun-
terclockwise.
2
Adjust the trigger slide position within the
marked range.
3
Retighten the mounting screw loosened at
step 1 and fasten the trigger slide.
Trigger Slide Adjustment
The throttle trigger position can be moved forward and backward. Furthermore, the
angle of the throttle trigger operating direction can be changed in 3 steps.
Note:
Be careful not
to damage the
case or wiring
as the trigger
XQLWLVGL൶FXOW
to move.
3
°
10 mm
3
°
Angle of the trigger operating direction
Remove the screws when adjusting
the angle.