10PX Transmitter - Manual

143
Returntotableofcontents
2
(Channel setup)
The channel list screen used for the front ESC channel is displayed. Tap the auxiliary chan-
nel that connected the front ESC channel.
- When all channels are in use, a screen saying "No assignable channel" is displayed, please turn off other mixing
and make an unused channel. You can check the mixing used on the channel setting screen (Linkage menu).
The number of chan-
nels varies depending
on the selected sys-
tem.
If there is no assignable
channel, tap [Close]. Turn
off other mixing and make
assignable channels.
3
(Drive ratio adjustment)
Adjust the front and rear motor controller
operation amount by or button. The
button increases and the button decreases
the rear ratio.
Both the front and rear ratios become 100%
4
(Mix mode setting)
Tap "MIX mode" (ON) or (OFF) to select ON/OFF.
"OFF": The EXP function of the 2nd CH and other settings are not mixed.
"ON": The EXP function of the 2nd CH and other settings are mixed.
5
(Trim mode setup)
Tap "Trim mode" (ON) or (OFF) to select ON/OFF.
"OFF": The trim of the 2nd CH is not mixed.
"ON": The trim of the 2nd CH is mixed.
6
When finished, return to the Mixing menu screen by pressing the HOME button twice.
Adjustment buttons
- Adjust with the and buttons.
- Return to the initial value by
tapping the [reset] buttons.
Rear rate (Rear mix rate)
0~100
Initial value: 100
Setting
- Tap (ON)/(OFF).
Setting
- Tap (ON)/(OFF).
The trim/dial select function can control the drive ratio with the digital dial or digi-
tal trim. (Linkage menu)
Trim/Dial Setting
As this function drives two separate motor controllers simultaneously, a mutual load
is applied. Use this function carefully so that the motor controllers are not damaged.
Futaba will not be responsible for motor controller, motor, and other vehicle trouble
due to the use of this function.
Note:
MIXINGMENU