10PX Transmitter - Manual

132
Returntotableofcontents
Front Brake
Brake 2/3
Rear Brake
Brake 1
or Brake 2/3
This function is used when the front and rear brakes must be adjusted independently
VXFKDVDVFDOH*3FDU7KLVPL[LQJXVHVWKHQGFKDQQHOIRUWKHUHDUEUDNHVDQGWKH
DX[LOLDU\FKDQQHOIRUWKHIURQW EUDNHVRUFRQWUROVWKHIURQWEUDNHVZLWKWKHDX[LOLDU\
channel servos, or controls the 2nd channel by the independent throttle and controls the
UHDUDQGIURQWEUDNHVZLWKWKHDX[LOLDU\FKDQQHO$OVRPL[LQJZKLFKYDULHVWKHDX[LO-
iary channels brake rate in proportion to steering operation is possible.
Brake Mixing
:KHQWKHWULJJHUUDWLR/LQNDJHPHQXĺ7KURWWOHPRGHZDVVHWWREUDNHRS-
HUDWLRQVWRSV:KHQXVLQJEUDNHPL[LQJVHWWKHWULJJHUPRGHWR
When the trigger ratio was set to 100:0
%UDNH PL[LQJ FDQ DOVR XVH WKH $%6 IXQFWLRQ IRU QG DQG UG EUDNHV([FHSW
IRUWULJJHUSRLQWDQGVWHHULQJPL[LQJLWFDQEHVHWH[FOXVLYHO\IRUWKHQGDQGUG
brakes side. Even if the A.B.S. function on the1st brake (2nd channel) side is OFF,
you can also use the A. B. S. function on the 2nd and 3rd brakes side alone. You can
set the ON/OFF of the A.B.S. (brake 2, 3) function with the switch select function
(Linkage menu).
Auxiliary channels A.B.S.
:KHQEUDNLQJPL[LQJLVDSSOLHGIURPEUDNHWREUDNHDQGEUDNH
-Brake 2 and brake 3 amount, brake 1,2,3 delay, and Brake 2 and brake 3 EXP and
ABS can be set.
6WHHULQJPL[LQJZKLFKYDULHVIURQWEUDNHVEUDNHDX[LOLDU\FKDQQHOVPDWFKHG
WRWKHVWHHULQJRSHUDWLRQFDQEHVHW)URQWEUDNHDX[LOLDU\FKDQQHOVFDQEHLQ-
dividually weakened according to the steering left or right operation amount.
Operation
MIXINGMENU