10PX Transmitter - Manual

127
Returntotableofcontents
*Shows the ON/OFF state
Caution
Always operate carefully before using this function.
When push switch, or trigger switch TS with preset function set is in the ON state, the servo (motor controller) is
locked in the preset position and does not operate even if the throttle trigger is operated. If the servo was oper-
ated at the wrong setting, you may lose control of the car (boat).
1
(Preset position setup)
Tap the value button of the [Preset]. Value
input buttons appear on the screen. Use the
[+] and [-] buttons to set the preset position
of the throttle servo.
2
When finished, return to the Linkage menu screen by pressing the HOME button.
Adjust button
Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Preset position
0~100
Initial value: 0
The function select trim/dial function can control the engine cut preset position with
the digital dial or digital trim (Linkage menu).
Trim/Dial Setting
The throttle servo operating position (preset position) set by this setting is unrelated
WRWKHHQYLURQPHQWRIRWKHUIXQFWLRQV0D[LPXPWRPLQLPXPVHUYRWUDYHOFDQ EH
set. However, the reverse function setting is enabled.
RACING MENU