10PX Transmitter - Manual

126
Returntotableofcontents
Home screen
Menu screen Racing menu screen Engine cut
Warning display
If the power switch is
turned on while the
engine cut switch is
on, an audible alarm
will be heard. Immedi-
ately set the engine cut
switch to OFF.
Engine cut ON/OFF is indicated
on the home screen for a few
seconds.
It is displayed in the home
screen, when the engine cut is
ON.
Engine Cut
When the switch is pressed, the throttle servo will move to the preset position without
regard to the throttle trigger position. This function is convenient when used to cut the
engine of boats, etc. (The switch select function in Linkage menu)
(Preparation)
- Use the switch setting function to the "Switch se-
lect". (Linkage menu)
When the switch is not set, "A switch is not as-
signed" is displayed. Tap [Switch select] to display
the switch selection screen and set the switch.
Engine Cut function adjustment
:KHQWKHWULJJHUUDWLR/LQNDJHPHQXĺ7KURWWOHPRGHLVVHWWRWKHEUDNH
side function will not operate. The preset position set here is the linkage reference.
Set the linkage so that the carburetor is fully closed in the preset adjustment range,
and the engine stops. The full throttle position is set by
"
advance
"
of the end point
function. Adjust the idling position with throttle trim.
When the trigger ratio was set to 100:0
RACING MENU