10PX Transmitter - Manual

118
Returntotableofcontents
Adjustment buttons
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
* Throttle trigger position
Servo travel
Trigger point
Reverse direction
Neutral
Normal
direction
High
Trigger point
Trigger point
Trigger point
5~95
Initial value: 30
6
("Trigger point" setup)
Tap the value button of the [Trigger point]. Value input buttons
appear on the screen. Use the [+] and [-] buttons to adjust
the operation point.
- Sets the throttle trigger position at which the traction control function is
performed. The number is the % display with the full brake position made
100.
Tap the [Normal] or [Reverse] to set the operating range.
"Normal": High range from the trigger point to the operating range.
"Reverse": Operating range from neutral to trigger point.
7
When finished, return to the Racing menu screen by pressing the HOME button.
Use switch the traction control function ON/OFF.
See the switch select function. (Linkage menu)
Switch setting
The throttle return amount, delay amount, and cycle speed can be controlled with
digital trim DT1 to DT6 or digital dial DL1, etc. with the trim/dial select function.
(Linkage menu)
Trim/Dial Setting
RACING MENU