User's Manual

http://www.gpsoftware.com/kb/q01-1038.htm. This support article will take

you through the process step-by-step, and has links to driver download sites

for most manufacturers.

Installing the Software-

After you have completed installation of the new video and sound card drivers,

you are now ready to install RealFlight G4.

1. Before installing the software, make sure to close any applications that

you are running. This includes virus scanning software and other

similar applications.

2. Insert Disc 1 (One) into the appropriate CD-ROM drive.

3. If Auto-Play is active, setup will begin automatically when the CD-

ROM drive is closed. Simply click the Install button when prompted.

If Auto-Play is not active, click Start on the task bar. Next, click Run.

In the dialog box that appears, type ‘d:\setup’ (assuming that ‘d’ is

your CD-ROM drive) and click OK.

Follow the on-screen instructions to complete the setup procedure. When

prompted, remove Disc 1 (One) and insert Disc 2 (Two). Following the on-

screen prompt, remove Disc 2 (Two) and insert Disc 3 (Three). Following

the on-screen prompt once again, remove Disc 3 (Three) and insert Disc 4

(Four). Upon completion of the installation, click OK.

Installing or Updating DirectX-

1. RealFlight will ask if you wish to install DirectX 9 on your PC. It is

important that your PC utilizes DirectX 9.0c or later. Click OK to

proceed to the DirectX License Agreement.

2. Click "I accept the license agreement" to install DirectX 9.0c.

Alternatively, if you do not wish to update DirectX at this time, click

Cancel.

3. If you have opted to accept the license agreement, click Next to

proceed with the installation. DirectX will install the necessary files to

update your PC.

4. When prompted, click Finish. Your PC will power down and then

restart once again.

Connect the InterLink Elite Controller-

The InterLink Elite controller uses the USB (Universal Serial Bus) port, so

there is little to do in the way of setup.