SPECIAL FEATURES Maximum class 7 channels * Transmitter FP-T7G • Dual travel ailerons, dual travel elevator built-in. • Maximum operation sensation through prudent design and adoption of open gimble and stick mechanism. * Receiver FP-R7L • Double conversion Receiver • Newly designed connectors improve electrical and mechanical reliability tremendously. * Servo FP-S15, FP-S15L (reverse rotation servo), FP-S15G (landing gear servo) •Output shaft is supported by miniature ball bearings.
CHARGE THE NICKEL-CADMIUM BATTERY BEFORE USING •Connect theTX jack of the FBC-2(F) charger to the charging jack of the transmitter and the RX jack of the charger to the receiver/servo nickel-cadmium battery and connect the Charger to an AC 117V (220V, 240V) socket. The TX and RX LE D of the charger will be lighted to indicate that the battery is being charged. •Charging time is normally about 15 hours. When the battery has not been used for some time, charge it for about 20 hours.
HANDLING 2-way level meter Antenna Handle Battery check switch Charging jack 6 channel lever 5 landing gear switch Dual travel elevator switch and trimmer 7 Channel lever Dual travel aileron switch and trimmer Power switch Adjust knob •Unlocked 4 rudder •Set the length by turning the entire knob and then lock 2 elevator * (engine control) 1 aileron 3 engine control *(elevator) *In Mode II, 2 elevator and 3 engine control are interchanged. Fig.
•Refer to Fig.2 for the operation of each channel and the name of each part. •When the power switch is set to ON, the pointer of the level meter will deflect. Since this indicates the antenna output, it should deflect to graduation 7. Since this indication is different when the antenna is contracted and when it is extended fully, check the indication when the antenna is extended fully.
•The antenna wire is color coded by frequency (band). •The connector wiring order is shown in Fig.6. •Pack the entire receiver in sponge and mount so that the antenna wire is as straight as possible. •Refer to Fig.4 when mounting the servo.
GUARANTEE Your NEW FUTABA Digital Proportional R/C system is guaranteed against defects in workmanship and material for 180 days from the date of purchase when the attached registration card is returned to us within ten days of purchase. This Guarantee is null and void if the R/C system has been improperly handled, damaged in a crash, or tampered with and does not cover the replacement of plastic housings or electronic components damaged due to the use of improper voltages.
FACTORY REPAIR SERVICE To insure prompt service, please follow the instructions given below 1 Charge the batteries for at least 18 hours prior to shipment 2 Return the system only Not your complete installation Remove the servos from their mounts and remove the foam padding from the receiver.
