Operation Manual

Sailplane Section
Setting the Aileron 1 Travel
You now set the left-side travel for Aileron 1. Press the
B key to activate left travel setting for Aileron 1 and set
the travel with the numeric keys E to M . The number
keys 0 through 100 input the value directly. The +
and - keys increase or decrease the value by 1. The
+/- keys may be used to reverse the throw direction.
If you are not sure what you are changing, hold the
stick to one side and press different keys — if there is no
effect, move the aileron stick to the other side and con-
tinue. Your setting may vary from —120 to +120%, with
an initial value of +100%.
Now set the right-side travel for Aileron 1. Press the
Q key to activate Aileron 1 right travel setting and set
the travel with the numeric keys as before.
Setting the Aileron 2 Travels
This procedure
is repeated for Aileron 2. Press the C
key to activate left travel setting for Aileron 2 and set the
travel with the numeric keys E to M as before.
Now set the right-side travel for Aileron 2. Press the
13 key to activate Aileron 2 right travel setting and set
the travel as before.
Setting the Flap Travels — 1 and 2
You now set the travel for Flap 2. Press the D key to
activate travel setting for Flap 2 and set the travel with
the numeric keys E to M. Your setting may vary from
-100 to +100%, with an initial value of +100%.
Now set the travel for Flap 1. Press the O key to
activate Flap 1 travel setting and set its travel with the
numeric keys. Its initial value is —100%.
Flap Trim Offset Setting
Flap trim offset sets the flap position from which
motion occurs. To input the flap trim offset amount
setting, move to the next screen by pressing the NXT R
key. Next, press the B key, then set the flap trim (left-
side lever, LS) to the position to be set and press the
F (SET) key.
Flap Trim Authority Setting
In the Flaperon mode, Flap Trim moves both ailerons
upwards or downwards together. To input the Flap Trim
Authority. Press the C key and set the rate with the
numeric keys F to M. You may choose any value from
0% to 100% for the Flap Trim Authority. The initial
setting is 30%, but a smaller number is recommended.
Sailplane Section, Page 150